jstarks243 jstarks243

10-08-2021
Engineering

contestada

The knob at the front of the miter saw about belt height is used to adjust the miter angle true or false

Respuesta :

Аноним Аноним

10-08-2021

Answer:

True.

Explanation:

There are two basic saw angles, and the little nob on the front controls the one angle, and the one on the rear controls the other.

Answer Link

Otras preguntas

don't spam answer only if you know What is the measure of angle x? Enter your answer in the box

SOURCE 2 QUESTION 2 Read the extract below and answer the questions that follow. Protests over power cuts disrupt morning traffic in Soweto Soweto residents too

Given the following cone, find the length of the slant. Round to the nearest tenth if necessary.

select the correct word form for 444,404 a four hundred forty four thousand four hundred zero tens four b four hundred forty four thousand four hundred four c f

Find the length of side x x to the nearest tenth.

Cambia la conjugación del presente al pretérito. Vive = Leo= Escuchamos = Bebéis = Vivimos = Se prueba =

Is a triangle with the sides of 32, 60, and 68 a right triangle?

Which point shows 1/8?

Which pairs of angles are alternate interior angles? Select all that apply. 3 20 N 517 618 co

good morning! someone please answer this, ill give you brainliest and your earning 50 points.